1. Dimension check (sampled)
We pulled a few pieces from each supplier's bag and measured the critical dimensions with a digital caliper — tip diameter and tip length against the sizes the customer gave us.
One honest catch from this batch: we found the caliper sitting in inch mode on some readings. A number without verified units is not a measurement, so those readings were re-checked before anything was recorded.
We don't claim every piece was measured. The readings describe the sampled pieces only.
2. Appearance check (sampled)
The sampled pieces, under a white background:
- Surface finish — even plating on the pieces we looked at? Any spots or cloudiness?
- Edges — any burrs or rough flashing you can feel with a fingertip?
- Finish match — this batch had a gold-toned route and a silver-nickel route; the sampled pieces looked right for their own finish, and the two routes were never mixed.
A sampled appearance check can catch obvious problems. It cannot promise the unsampled pieces look the same.
3. Function check (sampled, basic)
On the sampled pieces: tips fit the cord ends without forcing, and nothing caught skin during normal handling. That's the extent of it — a basic handling check on a few pieces, not a lab test. A firm manual tug is not a tensile test, and we don't call it one.
4. Check records
What exists from this batch:
- Dated photos of the inspection (setup, sampled pieces, labels).
- Weight records: packed bags weighed together, loose parts weighed separately — a weight check catches missing pieces, not defects.
- One QC CHECKED label per supplier bag, so the two routes can’t get mixed up downstream.
The QC CHECKED label means: the sampled checks described above were performed on this batch. It is not a third-party certification, not a full-spec pass, and not a claim about the pieces we didn't check.
5. What a sample check cannot prove
This matters more than the four checks above. Our inspection does not:
- Authenticate brands. We check dimensions, finish, and fit. We do not do brand-authenticity testing — a slider that measures correctly is still not a branded part unless the supply chain says so.
- Replace lab testing. No spectrometry, no salt-spray, no calibrated pull-force testing. If a customer needs lab data, we say so and arrange it separately.
- Prove anything beyond the sampled pieces. These results describe a few pieces from each bag — nothing more. They say nothing about the rest of the batch, and nothing about a future production run.
We'd rather tell a customer what we didn't check than let them assume we did.
Material is one of those limits: a bench check can catch plated steel, but telling solid brass from brass-plated zinc takes its own checks and paperwork.
Varestaq is an independent sourcing and product development partner based in China. Manufacturing partners are evaluated for each project; we do not operate a factory. Supplier capability, compatibility, MOQ, tooling requirements and lead time must be verified against your actual requirements before commitment.
Discuss your part, drawing or specification